Models And Options

Options

* Twin motor
* Incontinence cover

Models

One model is available in three sizes

Dimensions

Additional Dimensions

Small
Height 1060mm
Width 750mm

Medium
Height 1060mm
Width 750mm
I
Large
Height 1060mm
Width 820mm

Additional Info

More Details

Seat
* The air bag in the seat is encased within a foam base and covered by a layer of slow recovery foam. The front edge of the foam base has an extra layer of bonded polyester.
* The seating consists of an air filled, welded PVC bag encased in a foam cushion. Air filled bags and bonded polyester cushions are also used in the backrest sections and legrest area.

Backrest
* The air bags in the two sectioned contoured backrest are also covered by bonded polyester
* The backrest can be lifted from the frame of the back of the chair to gain access to the back of each cushion section. A zipper at the back of each section allows access to the air bags. Each air bag has a valve and stopper, enabling the amount of air in each backrest section to be altered if overfilled. Once adjusted, the backrest cushioning is secured at the base of the backrest by hook and loop.

Armrests
Wooden hand grips.

Legrest
Incorporated in the chair with a chaise and extends from the edge of the seat when in the raised position. The foot section of the legrest contains an air bag with a bonded polyester layer over the top.

Upholstery
Available in a wide variety of fabrics including a two way stretch fluid resistant fabric that is bacteria resistant and fire retardant treated. Combining this fabric with regular fabrics is possible.

Controls
* Hand held and can be located on either side of the chair
* When not in use the controls can be stored in pockets on the outside of the chair, for easy access

Castors
* Front and rear castors are standard

Customisation
* The amount of support in the backrest can be customised via adjustment of the amount of air in the backrest cushions.

The chairs features a "zero wall proximity" design which enables them to be positioned close to the wall while being reclined.

Option details
* Twin motor (back reclines to horizontal, with independent back, seat and lift function)
* Incontinence cover

Requirements

Place Of Manufacture

NSW, Australia

Standards

Some assistive technology needs to meet Australian or other standards. Standards may relate to materials, manufacturing and installation. Products that meet Australian or international standards will have written certification. To find out if a product meets Australian Standards ask the supplier to show you the certificate. For a fact sheet about standards contact us or visit www.ilcaustralia.org/home/standards.asp